<dl id="hblz6"></dl>

  1. <menuitem id="hblz6"></menuitem>

      1. Welcome to Dongguan Tai Fu Machinery Co., Ltd. official website

        Dongguan Tai Fu Machinery Co., Ltd.

        Dongguan Tai Fu Machinery Co., Ltd.

        Focus on the production and manufacture of injection molding machine for 10 years, national high-tech enterprise

        South China:136-8666-5453

        East China:139-2550-8791

        Contact
        TEL:13686665453

        Contacts:Manager Zeng
        phone:13925508791
        Email:2994331754@qq.com
        address:Fulong Yangwu Industrial Zone,Shipai Town,Dongguan City,Guangdong Provice,China

        history record

        The factors that affect the molding of the vertical injection molding machine

        source:   time:2018-04-14   Click:1002

        Vertical injection molding machine will have many factors in the process of molding, so that the products will be defective, such as temperature, injection time and so on. All of the products can be directly affected. Here is a detailed introduction to the following.

        One. Temperature

        As long as the temperature refers to the temperature of the mold and the heating temperature of the raw material, the temperature of the mold is an essential part of the injection molding. The lower the mold temperature is, the faster the heat conduction is lost, the lower the melt temperature is, the worse the fluidity is. Therefore, it is very important for injection molding to accurately grasp the mold temperature. Next is the heating temperature of raw materials. Some materials need to be heated in raw materials, such as BMC materials, because of their particularity.

        Two. Time control of injection molding

        The influence of injection time on product quality is mainly in three aspects.

        1, injection time is too long, easy to cause the product to pass the best molding temperature, resulting in the final molding is not good.

        2, injection time is too short to fully fill the mold, affecting the quality of products.

        3, when the injection time is shortened, the shear strain rate in the melt is increased, the higher the shear heat is, and the less heat lost by the heat conduction, so the melt temperature is high, the viscosity is lower, and the injection pressure needed to fill the cavity should also be reduced. This is a summary of the factors that affect the quality of the product when the vertical injection molding machine is formed. We have tested and debugged during the injection production and processing, so we can achieve the best level by debugging many times. Of course, you can also understand their debugging level or inquire about us.

        Popular tags:
        CONTACT THE TAIFU

        Contact: Manager Zeng

        Mobile phone:13925508791

        Fax:0769-81929375

        email:2994331754@qq.com

        Address: Fulong Yangwu Industrial Zone,Shipai Town,Dongguan City,Guangdong Provice,China

        Copyrights©2018 Dongguan Tai Fu Machinery Co., Ltd. All Rights Reserved case number:粵ICP備16078114號

          <dl id="hblz6"></dl>

        1. <menuitem id="hblz6"></menuitem>

            1. 国产亚洲精品线视频在线,校园专区另类小说,毛片,免费基地欧美毛片,欧美 日产 国产Ac,高清无码中文字幕无线